Jeep 2006 Commander User Manual download pdf (Page 26)

100

101

To Set the Alarm

The alarm will set when you use the remote keyless entry

transmitter to lock the doors and liftgate or when you use

the power door lock switch while the door is open. After

all the doors are locked and closed, a red light (located in

the instrument cluster) will flash rapidly for about 16

seconds to signal that the system is arming. During this

16 second pre-arm period, opening any door or the

liftgate will cancel the arming. If the system successfully

arms, the red light will flash at a slower rate to indicate

the alarm is set. A manual lock of the doors, either with

the door lock plunger located on the inside of the doors

or with the driver’s door key lock cylinder, will not set

the alarm.

To Disarm the System

To disarm the system, use the remote keyless entry

transmitter. Also, using a valid sentry key and moving

the ignition switch to the ON/START position will

disarm the system. If something has triggered the system

in your absence, the horn will sound three times when

you unlock the doors. Check the vehicle for tampering.

The Security Alarm System is designed to protect your

vehicle; however, you can create conditions where the

system will arm unexpectedly. If you remain in the

vehicle and lock the doors with the transmitter, once the

system is armed (after 16 seconds), when you pull the

door handle to exit the alarm will sound. If this occurs,

press the “Unlock” button on the remote keyless entry

transmitter to disarm the system. The Security Alarm

System will not disarm with a manual unlock, either

through the lock plunger located on the inside of the

door, or through a key in the driver’s door key cylinder.

26 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 439 440

Comments to this Manuals

No comments

Jeep 2006 Commander User Manual Page 26

Comments to this Manuals

Related products and manuals for Cars Jeep 2006 Commander