Jeep 2006 Commander User Manual download pdf (Page 267)

100

101

4LOWto4HI

With the vehicle at speeds of 0 to 3 mph (0 to 5 km/h),

key ON or engine running, shift the transmission into N

(Neutral), and raise the transfer case T-handle. The “4WD

LOW Indicator Lamp” in the instrument cluster will flash

and go out when the shift is complete. Release the

T-handle.

NOTE: If shift conditions/interlocks are not met, or a

transfer case motor temperature protection condition

exists, a “CHECK SHIFT PROCEDURES” message will

flash from the EVIC (Electronic Vehicle Information Cen-

ter). Refer to “Electronic Vehicle Information Center

(EVIC)” in Section 4 of this manual. (See page 186 for

more information.)

NOTE: Shifting into or out of 4WD LOW is possible

with the vehicle completely stopped, however difficulty

may occur due to the mating clutch teeth not being

properly aligned. Several attempts may be required for

clutch teeth alignment and shift completion to occur. The

preferred method is with the vehicle rolling 0 to 3 mph (0

to 5 km/h). If the vehicle is moving faster than 3 mph (5

km/h), the transfer case will not allow the shift.

Shifter T-Handle

STARTING AND OPERATING 267

1 2 ... 262 263 264 265 266 267 268 269 270 271 272 ... 439 440

Comments to this Manuals

No comments

Jeep 2006 Commander User Manual Page 267

Comments to this Manuals

Related products and manuals for Cars Jeep 2006 Commander