Jeep 2006 Commander User Manual download pdf (Page 137)

100

101

High Range (4WD Models) or 2WD Models

This is the normal operating mode for ESP in 4WD high

range and in 2WD vehicles. Whenever the vehicle is

started or the transfer case (if equipped) is shifted from

4WD low range or neutral back to 4WD high range, the

ESP system will be in this mode. This mode should be

used for most all driving situations. ESP should only be

turned to “Partial Off” or “Full Off” for specific reasons

as noted below.

Partial Off

This mode is entered by momentarily depressing the

⬙ESP Control Switch⬙. When in ⬙Partial Off⬙ mode, the

TCS portion of ESP, except for the “limited slip” feature

described in the TCS section, has been disabled and the

⬙ESP/TCS Indicator Light⬙ will be illuminated. All other

stability features of ESP function normally. This mode is

intended to be used if the vehicle is in deep snow, sand,

or gravel conditions and more wheel spin than ESP

would normally allow is required to gain traction. To

turn ESP on again, momentarily depress the ⬙ESP Control

Switch⬙. This will restore the normal “ESP On” mode of

operation.

ESP Control Switch

UNDERSTANDING THE FEATURES OF YOUR VEHICLE 137

1 2 ... 132 133 134 135 136 137 138 139 140 141 142 ... 439 440

Comments to this Manuals

No comments

Jeep 2006 Commander User Manual Page 137

Comments to this Manuals

Related products and manuals for Cars Jeep 2006 Commander