Jeep 2006 Commander User Manual download pdf (Page 16)

100

101

If the SKIM indicator light comes on during normal

vehicle operation (it has been running for longer than 10

seconds) a fault has been detected in the electronics and

the vehicle should be serviced as soon as possible.

NOTE:

•

The Sentry Key Immobilizer System is not compatible

with remote starting systems. Use of these systems

may result in vehicle starting problems and loss of

security protection.

•

Mobil Speedpass™, additional Sentry Keys, or any

other transponder equipped components on the same

keychain will not cause a key-related (Transponder)

fault unless the additional part is physically held

against the ignition key being used when starting the

vehicle. Also, cell phones, pagers, or other RF electron-

ics will not cause interference with this system.

All of the keys provided with your new vehicle have

been programmed to the vehicle electronics.

Important Note About Service

A four digit PIN number is needed to service the Sentry

Key Immobilizer System. This number can be obtained

from your authorized dealer. However, this number can

also be found on your customer invoice that you were

given upon receipt of your vehicle.

Replacement Keys

NOTE: Only keys that have been programmed to the

vehicle electronics can be used to start the vehicle. Once

a Sentry Key has been programmed to a vehicle, it cannot

be programmed to any other vehicle.

At the time of purchase, the original owner is provided

with a four digit PIN number. This number is required

for dealer replacement of keys. Duplication of keys may

be performed at an authorized dealer or by using the

Customer Key Programming procedure. This procedure

16 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 439 440

Comments to this Manuals

No comments

Jeep 2006 Commander User Manual Page 16

Comments to this Manuals

Related products and manuals for Cars Jeep 2006 Commander