Jeep 2006 Commander User Manual download pdf (Page 155)

100

101

2. Position the end of your hand-held transmitter 1-3

inches (3-8 cm) away from the HomeLink buttons.

3. Simultaneously press and hold both the HomeLink

button that you want to train and the hand-held trans-

mitter buttons. Do not release the buttons until step 4

has been completed.

NOTE: Some gate operators and garage door openers

may require you to replace this Programming Step 3 with

procedures noted in the ⬙Gate Operator/Canadian Pro-

gramming⬙ section.

4. The EVIC display will show “CHANNEL X TRAIN-

ING” (where X is Channel 1, 2, or 3). Release both buttons

after the EVIC display shows “CHANNEL X TRAINED.”

NOTE: If the EVIC display shows “DID NOT TRAIN”

repeat steps 2–4.

5. Press and hold the just trained HomeLink button and

observe the EVIC display. If the EVIC display shows

“CHANNEL X TRANSMIT” (where X is Channel 1, 2, or

3), programming is complete and your device should

activate when the HomeLink button is pressed and

released.

HomeLink Buttons

UNDERSTANDING THE FEATURES OF YOUR VEHICLE 155

1 2 ... 150 151 152 153 154 155 156 157 158 159 160 ... 439 440

Comments to this Manuals

No comments

Jeep 2006 Commander User Manual Page 155

Comments to this Manuals

Related products and manuals for Cars Jeep 2006 Commander