Jeep 2006 Commander User Manual download pdf (Page 61)

belt tight, however, any seat belt system will loosen

with time, so check the belt occasionally and pull it

tight if necessary). For the second and third row seat

belts with the automatic locking retractor, pull the belt

from the retractor until there is enough to allow you to

pass through the child restraint and slide the latch

plate into the buckle. Then, pull the belt until it is fully

extracted from the retractor. Allow the belt to return to

the retractor, pulling on the excess webbing to tighten

the lap portion about the child restraint. For additional

information, refer to ⬙Automatic Locking Mode⬙ ear-

lier in this section.

•

In the rear seat, you may have trouble tightening the

lap/shoulder belt on the child restraint because the

buckle or latch plate is too close to the belt path

opening on the restraint. Disconnect the latch plate

from the buckle and twist the short buckle-end belt

several times to shorten it. Insert the latch plate into

the buckle with the release button facing out.

•

If the belt still cannot be tightened, or if pulling and

pushing on the restraint loosens the belt, disconnect

the latch plate from the buckle, turn the buckle

around, and insert the latch plate into the buckle

again. If you still cannot make the child restraint

secure, try a different seating position.

•

Buckle the child into the restraint exactly as the

manufacturer’s instructions tell you.

•

When your child restraint is not in use, secure it in the

vehicle with the seat belt or remove it from the vehicle.

Do not leave it loose in the vehicle. In a sudden stop or

collision, it could strike the occupants or seat backs

and cause serious personal injury.

NOTE: For additional information refer to

www.seatcheck.org or call 1-866-SEATCHECK.

THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 61

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 439 440

No comments

Jeep 2006 Commander User Manual Page 61