Jeep 2006 Commander User Manual download pdf (Page 150)

100

101

To Vary the Speed Setting

When the Speed Control is ON, speed can be increased

by pressing and holding the RES·ACCEL button. When

the button is released, a new set speed will be estab-

lished.

Tapping the RES·ACCEL button once will result in a 2

mph (3 km/h) (3.7L/4.7L Models) or a 1 mph (2 km/h)

(5.7L Models) speed increase. Each time the button is

tapped, speed increases, so tapping the button three

times will increase speed by 6 mph (10 km/h) (3.7L/4.7L

Models) or 3 mph (5 km/h) (5.7L Models), etc.

To decrease speed while Speed Control is ON and SET,

press and hold the DECEL button. Release the button

when the desired speed is reached, and the new speed

will be set.

To Accelerate for Passing

Depress the accelerator as you would normally. When the

pedal is released, the vehicle will return to the set speed.

NOTE: When driving uphill, at elevations above 2,000

feet (610 meters), or when the vehicle is heavily loaded

(especially when towing) the vehicle may slow below the

SET speed. If the vehicle speed drops below 25 mph (40

km/h) for 5.7L models, or 30 mph (48 km/h) for 3.7L/

4.7L models, the Speed Control will automatically disen-

gage. If this happens, you can push down on the accel-

erator pedal to maintain the desired speed.

Vehicles may exhibit several 4-3 downshifts under the

above conditions. To reduce the frequency of the down-

shifts and to improve vehicle performance, it is advisable

to lock out overdrive. Press the TOW/HAUL switch on

the lower center switch bank (below the Heating/Air

Conditioning controls).

150 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

1 2 ... 145 146 147 148 149 150 151 152 153 154 155 ... 439 440

Comments to this Manuals

No comments

Jeep 2006 Commander User Manual Page 150

Comments to this Manuals

Related products and manuals for Cars Jeep 2006 Commander