Jeep 2011 Liberty User Manual download pdf (Page 334)

100

101

vehicle stopped or in motion. If the vehicle is stopped,

the ignition switch must be in the ON position with the

engine either OFF or RUNNING. This shift cannot be

completed if the ignition switch is in the ACC position.

2WD Or 4WD Auto To 4WD Low

When shifting into or out of 4WD LOW, some gear noise

may be heard. This noise is normal and is not detrimental

to the vehicle or its occupants.

Shifting can be performed with the vehicle rolling 2 to

3 mph (3 to 5 km/h) using the “Preferred Procedure” or

completely stopped using the “Alternate Procedure.”

Preferred Procedure

1. With the engine RUNNING, slow the vehicle speed to

2 to 3 mph (3 to 5 km/h).

2. Shift the transmission into NEUTRAL.

3. While still rolling, move the transfer case switch to the

desired position.

4. After the desired position indicator light is on (not

flashing), shift the transmission into gear.

Alternate Procedure

1. Bring the vehicle to a complete stop.

2. With the ignition switch in the ON position and the

engine OFF or RUNNING, shift the transmission into

NEUTRAL.

3. Move the transfer case switch to the desired position.

4. After the desired position indicator light is on (not

flashing), shift the transmission into gear.

NOTE: Steps 1 and 2 in the “Preferred Procedure” and

the “Alternate Procedure” are requirements for shifting

the transfer case. If these requirements are not met prior

to attempting the shift or while the shift attempt is in

332 STARTING AND OPERATING

1 2 ... 329 330 331 332 333 334 335 336 337 338 339 ... 541 542

Comments to this Manuals

No comments

Jeep 2011 Liberty User Manual Page 334

Comments to this Manuals

Related products and manuals for Cars Jeep 2011 Liberty