Jeep 2007 Commander User Manual download pdf (Page 384)

100

101

Front/Rear Axle Fluid

Front Axle Fluid Level Check

Lubricant should be to the bottom of the oil fill hole.

Rear Axle Fluid Level Check

Lubricant should be 1/2” (1 cm) below the oil fill hole.

Adding Fluid

Add lubricant only at the fill hole and only to the level

specified above.

Selection of Lubricant

Use only manufacturer’s recommended fluid, refer to

Fluids, Lubricants, and Genuine Parts for correct fluid

type.

Transfer Case

Fluid Level Check

Inspect the transfer case for fluid leaks. If a fluid leak is

found, the transfer case fluid level can be checked by

removing the filler plug located on the back side of the

transfer case. The fluid level should be at the bottomedge

of the filler plug hole when the vehicle is in a level

position.

Adding Fluid

Add fluid at the filler hole until it runs out of the hole

when the vehicle is in a level position.

Drain

First remove fill plug, then remove drain plug. Recom-

mended tightening torque for drain and fill plugs is

15–25 ft. lbs (20–34 N·m).

384 MAINTAINING YOUR VEHICLE

1 2 ... 379 380 381 382 383 384 385 386 387 388 389 ... 455 456

Comments to this Manuals

No comments

Jeep 2007 Commander User Manual Page 384

Comments to this Manuals

Related products and manuals for Cars Jeep 2007 Commander