Jeep 2007 Commander User Manual download pdf (Page 304)

100

101

The EVIC will display the “SERVICE TIRE PRESS. SYS-

TEM” message for 3 seconds. This text message is then

followed by a graphic, with “- -“ displayed for the pressure

value(s) indicating which of the Tire Pressure Monitoring

Sensor(s) is not being received. Refer to “Electronic Vehicle

Information Center (EVIC)” in Section 4 of this manual.

NOTE: Your system can be set to display pressure units

in PSI, kPa, or BAR.

If the ignition key is cycled, this sequence will repeat,

providing the system fault still exists. If the system fault

no longer exists, the “Tire Pressure Monitoring Telltale

Light” will no longer flash, the ⬙SERVICE TIRE PRESS.

SYSTEM⬙ text message will no longer display, and a

pressure value will be displayed instead of dashes.

NOTE: If your vehicle is equipped with a matching full

size spare tire, it has a tire pressure monitoring sensor,

and can be monitored by the Tire Pressure Monitoring

System (TPMS). In the event that the matching full size

spare tire is swapped with a low pressure road tire, the

next ignition key cycle will still show the “Tire Pressure

Monitoring Telltale Light” to be ON, a chime to sound, a

Low Pressure message to appear in the EVIC, and the

graphic display will still show the low tire pressure value

flashing. Driving the vehicle for up to 10 minutes above

15 mph (24 km/h) will turn OFF the “Tire Pressure

Monitoring Telltale Light” as long as the matching full

size spare tire or any other road tire(s) are not below the

304 STARTING AND OPERATING

1 2 ... 299 300 301 302 303 304 305 306 307 308 309 ... 455 456

Comments to this Manuals

No comments

Jeep 2007 Commander User Manual Page 304

Comments to this Manuals

Related products and manuals for Cars Jeep 2007 Commander