Jeep 2005 Wrangler User Manual download pdf (Page 252)

ignition key or start the engine. This means that your

vehicle’s OBD system is not ready and you should not

proceed to the I/M station.

b. The MIL will not flash at all and will remain fully

illuminated until you turn off the ignition key or start

the engine. This means that your vehicle’s OBD system

is ready and you can proceed to the I/M station.

If your OBD system is not ready, you should see your

authorized dealer or repair facility. If your vehicle was

recently serviced or had a battery failure or replacement,

you may need to do nothing more than drive your

vehicle as you normally would in order for your OBD

system to update. A recheck with the above test routine

may then indicate that the system is now ready.

Regardless of whether your vehicle’s OBD system is

ready or not ready, if the MIL symbol is illuminated

during normal vehicle operation, you should have your

vehicle serviced before going to the I/M station. The I/M

station canfail your vehicle becausetheMILsymbol ison

with the engine running.

REPLACEMENT PARTS

Use of genuine Mopar威 parts for normal/scheduled

maintenance and repairs is highly recommended to in-

sure the designed performance. Damage or failures

caused by the use of non-Mopar威 parts for maintenance

and repairs will not be covered by the manufacturer’s

warranty.

DEALER SERVICE

Your dealer has the qualified service personnel, special

tools and equipment to perform all service operations in

an expert manner. Service Manuals are available which

include detailed service information for your vehicle.

Refer to these manuals before attempting any procedure

yourself.

252 MAINTAINING YOUR VEHICLE

1 2 ... 247 248 249 250 251 252 253 254 255 256 257 ... 351 352

No comments

Jeep 2005 Wrangler User Manual Page 252