Jeep 2012 Liberty - User Guide User Manual download pdf (Page 80)

• The parking brake must be firmly engaged and the wheels chocked

during driveshaft removal and installation. The parking brake must

remain engaged unless the vehicle is securely and properly connected to

the tow vehicle, or the driveshaft is completely reinstalled. See your

authorized dealer for proper driveshaft removal and reinstallation

procedures, including flange orientation/alignment, use of thread-locking

compound, proper bolt torque specifications, etc.

Towing – Four-Wheel Drive Models

• Depress the brake pedal and turn

the ignition switch to ON/RUN

with the engine shut off.

• Shift the transmission into

NEUTRAL.

• Shift the transfer case into

NEUTRAL by holding down the

NEUTRAL Pin switch for four

seconds until the LED starts to

blink. The LED will stop blinking

and remain on when the shift is

complete.

• Start the engine and shift into DRIVE to ensure there is no vehicle

movement.

• Shut the engine off and shift the transmission into PARK.

• Place the ignition switch in the OFF position and remove the key.

• Apply the parking brake, attach the vehicle to the tow vehicle with a tow

bar and release the parking brake.

• Refer to your Owner's Manual on the DVD for further details.

CAUTION!

Towing with the rear wheels on the ground (while the driveshaft is

connected) will cause severe transmission damage. Damage from

improper towing is not covered under the New Vehicle Limited

Warranty.

WARNING!

• If the driveshaft is removed, the vehicle can roll even if the

transmission is in PARK, which could cause serious injury or death.

UTILITY

1 2 ... 75 76 77 78 79 80 81 82 83 84 85 ... 123 124

No comments

Jeep 2012 Liberty - User Guide User Manual Page 80