Jeep 2006 Liberty User Manual download pdf (Page 341)

100

101

To check the automatic transmission fluid level properly,

the following procedure must be used:

1. The vehicle must be on level ground.

2. The engine should be running at curb idle speed for a

minimum of 60 seconds.

3. Fully apply parking brake.

4. Apply the brakes and shift the transmission into P

(Park).

5. The fluid MUST be checked with the transmission in

P (Park) to be sure that the fluid level is accurate.

6. Wipe the dipstick clean and reinsert until seated.

Remove dipstick and note reading.

At normal operating temperature (approximately 180° F

(82° C), the fluid level is correct if it is in the HOT region

(cross-hatched area) on the oil level indicator. The fluid

level indicator should be in the COLD region at 70° F (21°

C) fluid temperature.

If the fluid level is low, add sufficient fluid to bring to the

proper level. Refer to Fluids, Lubricants and Genuine

Parts for correct fluid type.

Fluid is added through the dipstick tube.

NOTE: To prevent dirt and water from entering the

transmission after checking or replenishing fluid, make

certain that the dipstick cap is properly reseated.

Special Additives

The manufacturer recommends against the addition of

any additives to the transmission. Exception to this

policy is the use of special dyes to aid in detecting fluid

leaks.

MAINTAINING YOUR VEHICLE 341

1 2 ... 336 337 338 339 340 341 342 343 344 345 346 ... 423 424

Comments to this Manuals

No comments

Jeep 2006 Liberty User Manual Page 341

Comments to this Manuals

Related products and manuals for Cars Jeep 2006 Liberty